« | Home | »

Surfing – Which Surftech Board to Use For Kite Surfing?

By Monty | July 19, 2010

Gary Siskar recommends the JC Hawaii 5′10″ SD-3 in TL2 because “it is off the hook for me and kiting. It makes me surf like Dorian! Ha. No, really the board is great. I don’t know if it is my mind playing games but it feels really good under my feet. The TL2 feels like it has a bit of flew. I have rode the thing in everything from ankle slappers to about 3 feet overhead and it has been dreamy”.

Josh Mulcoy says the only board he ride is his TL2 model; the Stretch Mulcoy 6′0″ TL2. “For myself it is the perfect board. It is my favourite board for surf. So it crosses over perfect for kite. In kiting I want to ride the wave like I do surfing, it turn really well and holds the power of the kite. Also going upwind is quicker than ever before and not too bouncy as some boards the same size are. I have ridden this board for surf and kiting for half a year and haven’t even buckled it, super strong.” So for all you guys who like to really throw your board around this sounds like a great choice from Mulcoy.

mortgage refinance   These days many boards have an outer resin coating or “glass job” made from epoxy and that means the core is likely to be made from a type of foam that is very water absorbent, great stuff when it’s dry and the outer layer of resin and fiberglass are intact, big trouble if it’s exposed to water for very long. What happens is the water gets in between the foam core and outer resin shell then expands and contracts with temperature and atmospheric pressure changes to create delamination (separation) of the outer shell from the foam which opens the door to several bad developments.

* Weight gain – Heavy Boards Lower Performance

* Weakening – Wet Spots are Potential Break / Buckle Spots

* Yellowing – Lowers Resale Appeal

juegos futbol   Remember, Surfing is a solo sport and these exercises are for you and about you. You must not feel any competition when doing them. Enjoy them and do as much as you can so you can enjoy surfing for a long time.

To get us started here is an endurance Surfing Exercise Program for the gym or at home which should take about an hour.

property management   Work in the Shade!

* Prep is the first stage so make sure the ding is dry and all loose damaged material is removed.

* Then sand the area making sure to create a surface that’s clean so the new resin can get a grip for at least one inch or about 3 centimeters. Now it’s not essential, but if you have some masking tape you can tape around the outside of the repair area to maintain the work area separate from the undamaged area.

* Your ready to apply a thin layer of resin to the repair, but make sure your in the shade and position the ding so when resin is applied it won’t run or drip out of the targeted area.

* Apply enough resin to fill the ding and cover the sanded area then move the repair to direct sunlight.

* Ok, after 3 minutes more or less the resin is fully cured and ready go! Remove the tape if you like what you see, if not repeat the process to add a buildup until your satisfied. You can use your sandpaper to blend in any excess resin to the original form of the surfboard and you’re good to go!

And finally the Rusty 6′1″ Project: “this board pin tail holds so much through the turns, you really need to ride smaller fins. I ride Future F3 glass fins, these fins don’t bend through the high speed turns that this board will give you. I have used this board in indo to Hawaii, it’s a really great al around board.It does it all. A very nice board”.

You can be published without charge. You can to republish this article in your website or blog. Please provide links Active.

del.icio.us Digg Furl Reddit

Topics: 1 | No Comments »

Leave a Reply